More Cutting…

Last night, I rough cut the rest of the fuel tank panels.

I was able to clamp on a straight edge and follow it for all cuts.

I haven’t perfected the offset yet, so I do have some parts that might need a little more trimming.

A simple straight edge, clamped at an offset from the cut line, works pretty well. The wire standoff guide is far from ideal, though.

In any case, I have a stack of panels, ready to trim, clean and assemble!

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.