My TruGlo sights arrived!

I don’t have a sight pusher tool. Maybe someday, I will want one. For now, I just want these installed and I foresee leaving them there forever, so at lunch I took the pistol to a nearby gun shop where they were able to install the sights while I waited and for less than I was quoted on the phone. 🙂

Its hard to get a decent picture of the sights with the iPhone, but the dots are pretty bright. They were REALLY bright out in the sun. The real test will be at an indoor range.

I also got a stainless steel guide rod. IDPA rules ( 8.2.2.2.U ) allow replacing the guide rod with one made of a “material that is no heavier than stainless steel”. I’m not sure if the stainless guide rod will be any measurably better than the plastic one any more than I think a tungsten one would be better than stainless. It does cycle with slightly less spring noise and it looks really nice next to the stainless barrel.

That makes it pretty much official. The only thing left to change out is the trigger itself and I don’t really have any specific plans to do so. I might put on the Talon skate tape grip treatment. I have it already, but haven’t put it on. The Talon grip works pretty well on the Kahr. I also have an extended magazine release that I may or may not go to the trouble to install. Otherwise, I think I am done modifying this pistol.

It is a Generation 3 Glock 20C. I have the original barrel, a stock 10mm Auto non-compensated barrel and a Lone Wolf 40 S&W conversion barrel. I have three stock magazines. I have installed a 3.5 pound trigger connector and polished the trigger rub points. I have installed an “extended” slide release and extended slide lock. Today, I have added a stainless steel guide rod with a stock weight 17 pound spring and TruGlo TFO sights.